Mapping A Network Drive
|Line 1:||Line 1:|
= Windows =
= Windows =
Right click '''My Computer''' and select '''Map Network Drive'''.
Enter "\\storage01\'''username''' in the folder box, where '''username''' is your Pipeline username.
Click on connect using '''a different username'''.
Fill in the "Username:" box with "campus\'''username''' , and the password box with your Campus Domain password.
Click on '''OK''' and then click on '''Finish''' to complete mapping the network drive.
= Linux =
= Linux =
Revision as of 11:15, 13 July 2006
- Right click My Computer and select Map Network Drive.
- Enter "\\storage01\username in the folder box, where username is your Pipeline username.
- Click on connect using a different username.
- Fill in the "Username:" box with "campus\username , and the password box with your Campus Domain password.
- Click on OK and then click on Finish to complete mapping the network drive.
You can map a network drive to Storage01 using the smbmount utility. You can run the following command as a regular user:
$ smbmount //storage01/share /path/to/mount -o username=myusername,workgroup=campus,uid=mylocalusername,ip=storage01.stevens.edu
- //storage01/share is the mount location. Replacing 'share' with your domain username will map the network drive to your personal storage space. Please read the article on Storage01 for other possible locations.
- /path/to/mount is the location you want to map/mount the network drive at. You can map it to a mountpoint in your current directory such as 'mnt' by not using any slashes (full pathname is also fine)
- username=myusername - myusername should be replaced with your domain username.
- workgroup=campus - this specifies the domain to check your username and password against, leave it like this
- uid=mylocalusername - mylocalusername should be the name of your linux user (whoami will tell you this if you are unsure). This is the user who owns the directory/mountpoint you are mounting/mapping to.
- ip=storage01.stevens.edu - this specifies an "ip address" (a FQDN in this case) to locate Storage01 by. Leave as-is.
When you run this command, you should see a prompt similar to:
Type in your domain password and press enter. You will now be able to access the file stored on storage01 at the mountpoint you specified.